View Issue Details
| ID | Project | Category | View Status | Date Submitted | Last Update |
|---|---|---|---|---|---|
| 0002926 | MMW v4 | Install/Config | public | 2007-03-16 18:57 | 2007-07-18 04:36 |
| Reporter | rusty | Assigned To | |||
| Priority | urgent | Severity | minor | Reproducibility | always |
| Status | closed | Resolution | no change required | ||
| Summary | 0002926: Clean install --> MM scans the drive twice (status bar incorrect) | ||||
| Description | If I do a clean install (i.e. delete the db/registry entries/ini files) and then install and run MM 3.0.1023, then when I do a scan of the hard drive, MM restarts a second scan after the first scan is complete. note: this isn't a new bug, I just forgot to enter it previously. | ||||
| Tags | No tags attached. | ||||
| Fixed in build | |||||
|
|
i've tried it but can't reproduce |
|
|
I replicated the bug and saved a debug log to the ftp server. Note: the second scan begins around 428-429 seconds of the log. |
|
|
Note: petr made some changes that improved this issue in build 1026, however, build 1026--it no longer does 2 full scans. However, build 1026 still exhibits the following problems: 1) MM still does a second--albeit very rapid scan 2) The status bar is visually deceiving--because 2 scans are still done, the first scan occurs up until the halfway mark of the status bar, and the second scan (which takes only a few seconds) occurs as the second half of the status bar is filled. |
|
|
Seems to work correctly in 1050. Closing. |
